Motorcycle
Motorcycle

Installation Instructions

 13-100 Sportboard, R1200C

Tools Required:

Small screwdriver,

Parts Kit, Included:

2 Ea. 5/16" X 1 ¼" Grooved Clevis Pin with E-Clip

4 Ea. 3/8" Wave Washer S.S.

Remove Stock Foot Pegs:

1. With screwdriver remove E style retaining clip.

2. Wiggle foot peg up and down as you remove the clevis pin. The foot peg is under some spring pressure, be careful as you pull out the pin.

3. Save all stock parts, never throw away original parts.

Install Sportboard:

1. Install a wave washer on either side of the mounting bracket of the footrest plate and fit it into the clevis.

2. Install new 5/16" grooved clevis pin and install E style retaining clip.

3. Check to make sure that the brake and shift levers are fully functional and that the side stand is unimpeded.

4. Check the Sportboards to insure that everything is functioning properly.

Search Products

Ilium Works is proud to announce the 29-200 HIGHWAY PEGS for the R1250 GS Adventure.

The factory engine guard bar configuration has presented quite a challenge when it comes to properly mounting a comfortable highway peg. Our new part number 29-200 Highway Pegs address this problem with a unique mounting system. A gracefully curved 1/4" X 1” stainless steel bar connects the upper and lower bars of the factory engine guard and provides a sturdy foundation to mount the highway pegs in the proper location.

The 29-300 GSA Highway peg is offered with the Gripper pad.

Carefully designed Rear Crash Bars to help protect your expensive panniers and mufflers, these minimalist design bars will not interfere with passenger comfort or the clean lines of your R1200RT Oil head, R1200RT Water Cooled, R1250RT or K1600GT / GTL / GTLE.These Rear Guard Bars, Part# 11-800BL are designed to work in conjunction with our P/N 19-600 Highway Pegs to offer the best overall protection for your 2005 – 2013 R1200RT in the event of a drop or tip over. These can also be used in conjunction with other manufacturer’s engine guard...

These Rear Guard Bars, Part# 30-800 / 30-800BL are designed to work in conjunction with our P/N 30-200 / 30-200BL (R1200RTW) or 36-200 / 36-200BL (R1250RT) Engine Guard Bars to offer the best overall protection for your R1200RT WATER COOLED or R1250RT in the event of a drop or tip over.  These can also be used in conjunction with other manufacturer’s engine guard bars as well.  These bars are constructed of heavy wall  (1” X .120” ) steel tubing and TIG welded to 7 ga. cold rolled steel brackets.  After shot blasting with stainless steel media, th...

Powered By Zomix Content Management Systems copyright © 2024