Installation Instructions
11-300 Sportboard, R1200RT
Tools Required:
Small screwdriver, pliers, 3/8" wrench (1/8" Allen wrench, supplied in Parts Kit).
Parts Kit, Included:
2 Ea. 5/16" X 1 3/4" Clevis Pin
2 Ea. Cotter Pin
1 Ea. 1/8" Allen Wrench
1 Ea. Side Stand Foot
Place motorcycle on center stand.
Remove Stock Foot Pegs:
1. With screw driver and pliers, straighten and remove cotter pin.
2. Wiggle foot peg up and down as you remove the clevis pin. The foot peg is under some spring pressure, be careful as you pull out the pin.
3. Save all stock parts, never throw away original parts.
Install Sportboard:
1. Check to see that neither of the two ¼-20 nylon tipped setscrews are protruding from backside of mounting bracket.
2. Fit mounting bracket into clevis on footrest plate and install clevis pin. At this point the Sportboard will have some back and forth movement.
3. Orient clevis pin so that the cotter pin hole is facing rearwards. It will be easier to install the cotter pin after adjusting the setscrews in the mounting bracket.
4. Using the supplied 1/8" Allen wrench, tighten the two setscrews evenly to take out any play and align the Sportboard parallel to the motorcycle. Tighten each setscrew firmly and evenly with fingers only. Do not use pliers or a cheater on the Allen wrench.
5. Insert the end of the cotter pin into the clevis pin and push forward until it seats into position. Bend legs around the clevis pin.
6. Check to make sure that the brake and shift levers are fully functional and that the side and center stand are unimpeded.
7. Check the Sportboards to insure that everything is tight and functioning properly.
Install Side Stand Foot:
1. Remove the two screws and the top plate.
2. Install the bottom plate on the side stand.
3. Put top plate on and install the two screws.