Motorcycle
Motorcycle

Installation Instructions

 10-200 Brake Extension, R1150RT, R1200RT

Tools Required:

½" wrench, 3/8" drill bit, drill motor, file, small piece of wood. (3/16" Allen wrench, supplied in Parts Kit).

Parts Kit, Included:

1 Ea. Brake Extension Nut

1 Ea. ¼-20 X 2 ¾" Cap Bolt

1 Ea. 3/16" Allen Wrench

Place motorcycle on center stand.

1: Place the piece of wood between the brake lever and the side case of the motorcycle.

2: Center the drill bit in the brake lever, and drill the rest of the way thru the brake lever. You should hit the piece of wood when the drill comes out the backside of the brake lever. (Do not drill thru the wood into the side case).

3: Take the file, and file the burr off of the backside of the brake lever.

4: Slide brake extension over the brake lever.

5: Pull down on the brake lever and install the nut into the hole you just drilled.

6: Using your ½" wrench to hold the nut, install and tighten the bolt with 3/16" Allen wrench.

 

Search Products

Ilium Works is proud to announce the 29-200 HIGHWAY PEGS for the R1250 GS Adventure.

The factory engine guard bar configuration has presented quite a challenge when it comes to properly mounting a comfortable highway peg. Our new part number 29-200 Highway Pegs address this problem with a unique mounting system. A gracefully curved 1/4" X 1” stainless steel bar connects the upper and lower bars of the factory engine guard and provides a sturdy foundation to mount the highway pegs in the proper location.

The 29-300 GSA Highway peg is offered with the Gripper pad.

Carefully designed Rear Crash Bars to help protect your expensive panniers and mufflers, these minimalist design bars will not interfere with passenger comfort or the clean lines of your R1200RT Oil head, R1200RT Water Cooled, R1250RT or K1600GT / GTL / GTLE.These Rear Guard Bars, Part# 11-800BL are designed to work in conjunction with our P/N 19-600 Highway Pegs to offer the best overall protection for your 2005 – 2013 R1200RT in the event of a drop or tip over. These can also be used in conjunction with other manufacturer’s engine guard...

These Rear Guard Bars, Part# 30-800 / 30-800BL are designed to work in conjunction with our P/N 30-200 / 30-200BL (R1200RTW) or 36-200 / 36-200BL (R1250RT) Engine Guard Bars to offer the best overall protection for your R1200RT WATER COOLED or R1250RT in the event of a drop or tip over.  These can also be used in conjunction with other manufacturer’s engine guard bars as well.  These bars are constructed of heavy wall  (1” X .120” ) steel tubing and TIG welded to 7 ga. cold rolled steel brackets.  After shot blasting with stainless steel media, th...

Powered By Zomix Content Management Systems copyright © 2024